sharp pair of tweezers or a needle or a toothpicks should be able to help. tons of instructions on how to do it in this thread, but I will add my 2 cents as a phone tech and say that if it’s a lightening port, you want to keep your tool as vertically in the middle of the port as possible while scraping horizontally. for USBC, keep your tool as close to the walls as possible while avoiding the center “tab”. this is so you don’t scrape the contacts. if you do that, you will need a port replacement (usually 80-100$ on most devices). once you scrape as much as you can out. you can use an old toothbrush or whatever works to brush the port clean with some isopropyl to clean any dirt on the contacts, which will come off easily now that it’s not being supported but the other debris you cleaned out with the tool.
whatever works best! it’s just kinda hard to find something plastic that skinny and sharp, and I use tweezers as it’s the most efficient (but also the most prone to damage if you make mistakes I guess).
starting with the brush/isopropyl is not a bad idea for cleaning the contacts (and should be the first thing tried if a device isn’t charging) but it usually doesn’t actually get stuff out of the port. if a port is only charging at a specific angle, it’s cause there’s debris stuck in there. in my experience it’s usually very hard to get with a brush as it’s been compacted and cemented over however long you’ve had the device.
sharp pair of tweezers or a needle or a toothpicks should be able to help. tons of instructions on how to do it in this thread, but I will add my 2 cents as a phone tech and say that if it’s a lightening port, you want to keep your tool as vertically in the middle of the port as possible while scraping horizontally. for USBC, keep your tool as close to the walls as possible while avoiding the center “tab”. this is so you don’t scrape the contacts. if you do that, you will need a port replacement (usually 80-100$ on most devices). once you scrape as much as you can out. you can use an old toothbrush or whatever works to brush the port clean with some isopropyl to clean any dirt on the contacts, which will come off easily now that it’s not being supported but the other debris you cleaned out with the tool.
Why not use plastic or tooth pick and start with alcohol?
whatever works best! it’s just kinda hard to find something plastic that skinny and sharp, and I use tweezers as it’s the most efficient (but also the most prone to damage if you make mistakes I guess).
starting with the brush/isopropyl is not a bad idea for cleaning the contacts (and should be the first thing tried if a device isn’t charging) but it usually doesn’t actually get stuff out of the port. if a port is only charging at a specific angle, it’s cause there’s debris stuck in there. in my experience it’s usually very hard to get with a brush as it’s been compacted and cemented over however long you’ve had the device.
That’s great, thanks for explaining.