@swordsmanluke@programming.dev to 3DPrinting@lemmy.worldEnglish • 1 year agoDon't forget to change your z offset after swapping nozzlesmessage-square19fedilinkarrow-up183arrow-down12file-text
arrow-up181arrow-down1message-squareDon't forget to change your z offset after swapping nozzles@swordsmanluke@programming.dev to 3DPrinting@lemmy.worldEnglish • 1 year agomessage-square19fedilinkfile-text
minus-squareLazaroFilmlinkfedilinkEnglish3•edit-21 year agoI preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.
I preheat to 170°c. That allows the filament to be soft enough to be cleaned (with tweezers or a brush, it peels off in one piece most of the time) without oozing. Then I do a 10mm retract before probing.
That’s smart!