Hi
Stock nginx built into Synology DSM won’t cut it, so I decided to install Nginx Proxy Manager. Before doing so, I created a macvlan and assigned the NPM container to use the assigned IP. Once install is finished, and I try to launch NPM, it fails to load. I tried the same install without macvlan, and it works and loads just fine. I have installed many other containers on macvlan, so I know what I am doing and have the knowledge and experience, but I have never run into this before where there seems to be a conflict I am not aware of.
Help? Anyone?
Here, let me show you what I did and you tell me where I went wrong.
SSH into Synology NAS and Create macvlan network with modified command below to my system:sudo docker network create -d macvlan \-o parent=eth0 \–subnet=192.168.1.0/24 \–gateway=192.168.1.1 \npm_network
Install Nginx Proxy Manager docker container
Assign NPM to use the new macvlan network and assign it an IP on the subnet that’s not already in use with the following command:docker network connect --ip 192.168.1.99 npm_network nginx_proxy_manager
Go into portainer and under container settings for NPM, ensure the container is connected to both the new macvlan with the info we used and also connected to the default bridge network.
This is where I hit a wall. I still cannot connect to my web interface at this point when I feel like I should be able to with the macvlan ip 192.168.1.99
What am I doing wrong?
So basically all you did was create a docker network with no macvlan on your synology. The docker network you created will simply look for a macvlan and communicate with it. There needs to be an actual macvlan there to communicate with. You really should read through my responses again.
Here are some pointers:
Your step 2 needs an auxiliary address for your host. –aux-address=“host=192.168.2.201”
Look at my step 3. You have to run those commands to setup the macvlan on your synology. You have to use your auxiliary host address in the series of commands I showed you. When you run them properly you will see the host show up in your router.
Okay, so here’s where I’m confused. From my understanding you say all I did is create a docker network and I need to create a macvlan but the ‘npm_network’ that I created literally says macvlan beside it in the network tab of either container manager or portainer. Even the command literally says ‘create macvlan’ so I am confused why you say that’s not a macvlan and only a docker network.
Am I making sense? Also, two other outdated guides ive seen on this describe it the same way. The way you describe it is a first that I’ve seen. Not saying you’re wrong, but there’s certainly a difference I’m noticing.
Those other guides assume you already have a macvlan and want to use docker on it. Like I said, not many complete guides out there. Mine is the most comprehensive you’ll find.
The gist of it is, you create a macvlan network on your NAS then you place a docker network on that macvlan network.